I in fact have a couple of kinks now in the HS so that it would fit without touching either one (I'm a perfectionist so this is really bugging me!). I had to bend the HS towards the pipe, very little clearance around the floorboard and the brake pedal. At first, even with the spacers, the end of the HS touched the floorboard bracket (yes it's scratched now). The issue (at least for mine) is that there should be a notch on the HS by the header bolt (the one towards the side the pipe is on) as it partially covers the bolt and does not allow it to go up far enough. There is little room to make any ajustments to it. I did have a problem with the front header heat shield (no problem with the pipe itself). I will post dyno as soon as I have time to get it done. A bit too much vibration for my liking though. Fired right up, no back fires and excellent throttle response.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |